Installation
Cut Plate Height plus 5/16"
Apply mortar to the angled interior inside of clip. Slide clip over the edge of the block.
Slip the weld plate into position. Mortar second clip and install upside down on top block.
Set top block with clip installed over weld plate in correct position. Allow mortar to dry completely before grouting.
"Since we started using EZ Clips, we have experienced real gains in productivity. The man-hours required to set plates, the cost and mess of adhesives or epoxy and clean up after blown plates during grouting are reduced or totally eliminated."

Gary Buxton
General Masonry Contractor, 35 years
Typical 4" x 8" Plate
Typical 12" x 12" Plate